This will start the flow of gas so you can light the flame. First things first, try to light it again before assuming there is a major problem.
Go back to the gas valve and turn the knob to “pilot.” by pushing the knob down, you will start the flow of gas to the pilot.
How to turn on hot water heater pilot light. Once the pilot lights, keep holding the knob/button. If the release valve seems dirty or broken, you will either need to clean or replace some parts. Otherwise, if the pilot light is not functioning correctly, the.
Now off the regulator valve. First locate the temperature controls. You just simply leave your hot water tank on the pilot and you will find the water warm when you come back.
Keep holding the pilot igniter button for 20 to 30 seconds until it lights. The general technique of lighting a pilot light involves looking for a knob with temperature settings and a notch that says, “pilot” or “pilot light” on the access panel. If you have trouble locating it, it’s usually located at the front of the water heater.
Turn the control valve to “on”. This is where we can move on and check the interior door panel for the directions to find out how to turn on gas water heater pilot light. You should respond by moving the gas control valve to the ‘off’ position.
A red light shows that the water heater is shutting down. It’s easy to turn your water heater pilot back on. While still holding down the knob or button, use an extended lighter to reach into the access and ignite the pilot.
Some water heaters have a separate button for pilot mode, usually a red one, which you’ll press and hold. If there is no release of any combustion agent, the pilot light will fail to start. When relit, the water heater pilot light flame should wrap around the thermocouple bulb.
Your first step is obvious: On most hot water heaters this is a small flame or spark symbol. Turn the gas knob to “pilot,” press and hold it down.
If the circuit board is damaged and it cannot generate the power the spark igniter needs, the red light will come on and stay on. This makes it one of the ways that you can make use of the pilot mode. The pilot light starts after the igniter sparks, which causes this flame to activate the water heater.
When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks. For gas heaters, you will need to check on the release valve. Also when you are planning to go away for some period during winter, then you can leave your hot water tank on a pilot mode.
If there’s a leak, then igniting a flame can cause an explosion. If the water heater pilot doesn’t light after this amount of time, you may need to press the. While holding the pilot igniter button down, press the spark generator button.
While still holding the gas down, light that pilot. Find that and the ignitor button right on the panel. To relight the pilot, turn the knob to the pilot position.
Once in the pilot position, press the control knob down fully and keep holding it down for 30 seconds. If that’s clear, you can proceed. To prevent problems with the water heater pilot light, it is crucial to carefully read the manufacturer's instructions, especially how to maintain the gas water heaters and how to light the pilot.
Sniff around the pilot light area and make sure you don’t smell any gas. We want to put the heat to the minimum. How to turn your water heater pilot light back on.
The below video will demonstrate how to light your water heater pilot light. After five minutes it is safe to proceed. But first, check for a gas leak.